Description

SET OF 2 REPLACEMENT BATTERY CLIPS WITH HINGE PINS We designed these clips to replace the inferior factory clip on your Uniden SDS100 scanner. The factory clip is easy to break or wear out. This one is made of a much stronger carbon fiber-reinforced polycarbonate that is simply not going to break, EVER. We include a stainless steel hinge pin too. Installation is very easy - takes less than one minute: 1. Remove battery door and battery 2. Remove the two lower Philips head screws inside the battery compartment 3. Gently pry the case open just enough to allow you to remove the old clip 4. The new clip slips right into place 5. Reinstall screws and you are done We design and produce many custom parts for this scanner (links to our listings): Here’s an inexpensive stand that holds the scanner up on your desk. Looking for a way to mount this scanner to your AMPS car mount? We make replacement knobs that glow in the dark! Do you have the small battery? Here’s a stand that will hold it nicely. Here’s our most popular desk stand that you will love to use. Lose your belt clip stud? Here’s a replacement set of three. Like to use it in your car? Here’s a nice cup holder mount. _gsrx_vers_1318 (GS 8.4 (1318))